r
WILD WHEELIES!
Jump your vehicle off a ramp. Pull the left control back as soon as the
front tire is airborne: your vehicle will tumble and fl ip in mid-air. Push the
left control all the way forward as soon as you land. Depending on speed
and distance, your vehicle may Either way, the gyro stabilizer will keep it
going for more cool stunt action!
*
With the rider’s feet unlocked, you can perform the amazing walking
wheelie stunt…depending on speed and distance.
t
STOP & START!
Push the left control all the way forward to accelerate to full speed. Then
quickly jam the left control all the way back. Your vehicle will go into a
cool power skid. Now quickly jam the left control all the recover and keep
driving to the next exciting stunt!
VII. QUICK TIPS
1. When your vehicle starts to lose power, it may lose functions or
performance. It’s time for fresh batteries
(or a recharge). Your vehicle’s running time may change depending on
your driving style.
2. Radio interference can make your vehicle run poorly. Interference can be
caused by other R/C vehicles running on the same frequency, electrical
wires, large buildings, CB radios or other wireless gear. Try to stay
away from these!
3. Point your transmitter antenna up - not down toward your vehicle. If
your vehicle gets too far away,
it won’t work properly.
4. Don’t drive your vehicle through water or snow.
If your vehicle does get wet, wipe it with a towel and allow it to dry
completely.
5. Don’t store your vehicle near heat or in direct sunlight. Always turn
switches OFF and remove all batteries for storage.
VIII. BATTERY INSTALLATION
Your vehicle will not operate with the TYCO® R/C TMH® FlexPak®
Battery Pack and Charger. For detailed information regarding rechargeable
battery charging and safety, please refer to “Battery Charging/Care”
Section.
q
VEHICLE
1. Turn vehicle over. Fold the FlexPak battery pack over as shown, so that
the label marked 4 in the upper left-hand corner is facing up, as shown.
The metal battery contacts should be on the bottom, as shown.
2. Snap the folded FlexPak battery pack into the battery compartment with
the contacts as shown. Rotate the battery compartment latches inward
toward the battery pack until they engage fully, locking the battery pack
into position.
3. To remove the battery pack, rotate the battery compartment latches to
release the battery pack.
w
TRANSMITTER
1. Install one 9-volt battery with po/-) as shown inside battery
compartment.
2. The transmitter battery will last much longer then the run time of the
rechargeable battery pack.
BATTERY CHARGING/CARE
X
CAUTION:
Use only the charger supplied with this toy. Do not use any
other charging source.
Use only Tyco® R/C TMH® FlexPak® NiMH battery packs. Other batteries
may leak or rupture, causing personal injury and damage.
1. Plug the battery charger into standard wall outlet.
2. Hold the battery pack fully open, with the metal contacts at the top, as shown.
The labels marked 1 and 2 in the upper left-hand corner should be facing you.
Now slide the battery pack securely into the charger.
3. To disconnect, push the red button on the side of the charger. Hold the red
button down while you slide out the battery pack.
4. After charging, the battery pack may feel warm. This is normal for fully
charged batteries.
5. New battery packs must be charged for 5 1/2 hours the first two times
charged. After that, subsequent charges will require 4 hours. Charging the
battery pack for more than 4 hours will not give you a longer running time. 4
hours is all that is required for a fully charged battery pack.
6. Unlike NiCd (Nickel-Cadmium) rechargeable batteries, your TMH® FlexPak®
battery pack may be recharged at any time, irrespective of the level of charge
1
2
TMH® FLEXPACK®
7.2V NiMH
1 x 6 AA,
1200 mAh
r
1.
2.
3.
1.
2.
3.
t
q
TMH® FLEXPACK®
7.2V NiMH
1 x 6 AA,
1200 mAh
9V d.c.
w
1.
2.
3.
4.
5.
