4
ELECTRICAL REQUIREMENTS
Any electrical work required to install this appliance should be carried out by a qualified electrician or competent
person. The manufacturer declines any liability should these safety measures not be observed.
Warning: This appliance must be earthed.
•
Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating
plate.
•
The plug must still be accessible after the appliance has been installed.
•
The appliance should not be connected to the electrical supply by means of an extension cable.
The appliance is supplied with a 13 amp plug fitted. In the event of having to
change the fuse in the plug supplied, a 13 amp ASTA approved (BS 1362) fuse
must be used. Should the plug need to be replaced for any reason. The wires
in the mains lead are coloured in accordance with the following code:
Green and Yellow: Earth
Blue: Neutral
Brown: Live
The wire coloured green and yellow must be connected to the terminal marked with the letter “E” or by the earth
symbol or coloured green and yellow. The wire coloured blue must be connected to the terminal “N”. The wire
coloured brown must be connected to the terminal marked “L”.
INSTALLATION OF YOUR WINE CABINET
•
Remove the exterior and interior packing.
•
Note:
Before connecting the Wine Cabinet to the power source, let it stand upright for approximately 2 hours. This
will reduce the possibility of a malfunction in the cooling system from handling during transportation.
•
Clean the interior surface with lukewarm water using a soft cloth.
•
Install the handle on the left side of the door.
•
Place your Wine Cabinet on a floor that is strong enough to support it when it is fully loaded. To level your Wine
Cabinet, adjust the front levelling foot at the bottom of the Wine Cabinet.
•
Locate the Wine Cabinet away from direct sunlight and sources of heat (stove, heater, radiator, etc.). Direct
sunlight may affect the acrylic coating and heat sources may increase electrical consumption. Extreme cold
ambient temperatures may also cause the unit not to perform properly.
•
Avoid locating the unit in moist areas.
•
The Wine Cabinet should be positioned where the ambient temperature is between 5°C and 35°C. If the ambient
temperature is above or below this range, the performance of the unit may be affected. Placing the appliance in
extreme cold or hot conditions may cause the interior temperatures to fluctuate. The range of setting
temperatures may not be reached.
•
Plug the Wine Cabinet into an appropriate socket. Should the plug require changing, use the instructions as given
in the Electrical Requirements section.
HW07MA
This model is designed for built-in installation only. Cooling air is taken in through the vents in the front plinth. This
area must be kept clear when the appliance is installed. Appliance dimensions are 870 x 147 x 475mm (H x W x D).
The minimum cabinet opening dimensions required are 878 x 162 x 525mm.
HW19MA
This model is designed for built-in or free-standing installation. The warm air is expelled through the vents in the front
plinth. This area must be kept clear when the appliance is installed.
Appliance dimensions are 870 x 295 x 575mm (H x W x D). The feet are adjustable so the cabinet height can be
increased up to 890mm. The minimum cabinet opening dimensions required are 878 x 310 x 625mm.
