Host ARIDEX, Manual, Page: 21 / 48

Replacing Carbon Brushes - Brush Unit Power Cord Care
If the brush unit motor slows down or begins to run Inspect cord for damage before each use.
erratically, inspect the carbon brushes for wear. While in use, do not pull or carry by the cord.
Do not unplug by pulling on cord. To unplug,
Remove the access cap (#3) from the outer grasp the plug, not the cord.
brush unit cover.
When cord is not in use, wrap tightly around
Remove the inner access cap (#29) from the the upper half of the hood.
brush unit housing.
Remove the carbon brush (#28) from the holder.
Caution: Note the position of the bracket
holding the carbon brush for reinstallation
Inspect the carbon brush and if the carbon is
below 1/2", a new carbon brush should be
installed.
Reinstall the carbon brush by compressing the
spring and thread the inner access cap back
into place.
18