Hoshizaki Lancer Superchiller Remote R8E V2 Series, Installation, Operation & Service Manual

Page: 11 / 27

R8E V2 Superchiller Remote 230V / 50Hz
lancerbeverage.com
Page 11 of 27
Hoshizaki Lancer reserve the right to change specifications without notice. Part No: 68000009
Images are for illustration purposes only as product may vary. No 027 – 7 March 2013
6.9 Connecting to water supply

Using appropriate tubing and fittings connect a 10mm water supply line from Superchiller
carbonator pump inlet to a filtered, regulated water supply. (See Postmix circuit diagram page
13-15). Installation in accordance with AS/NZS 3500.1 and AS/NZS 3500.2.

Turn on water supply, check for leaks, adjust water regulator to 172-275kpa.

Open the bypass ball valve on the carbonator relief and bypass assembly until water flows from
CO
2
exhaust tube; then close the bypass ball valve. For dual carbonators, repeat this operation
for each carbonator.
Caution
Maximum water supply pressure to be 275 kpa.
Normal operating water temperature should be within 7°C to
32°C.
6.10 Connecting to CO2 supply
Warning
As carbon dioxide (CO
2
) displaces oxygen; prevention of CO
2
leaks is paramount. If a leak is suspected, immediately ventilate
the contaminated area, before attempting repairs.

Connect CO
2
supply line from regulator to gas inlet on carbonator. (See Postmix circuit diagram
page 13 – 15 for details)

Adjust CO
2
Regulator supplying Carbonator to 550 kpa.

Turn on CO
2
supply.
6.11 Filling unit with water
Remove Superchiller lid and fill water bath until water flows out overflow tube.
NOTE:
Do not use water supplied from newly installed carbon filter as ice bank control operation will
be adversely affected.
6.12 Commissioning

Unplug carbonator and recirculation pumps power supply leads from electrical box located
under lid.

Connect Superchiller power supply lead to an appropriate 3 pin socket outlet and switch on.

When Superchiller ice bank is fully formed (approx. 4 hours) the remote compressor and
condenser fan will cycle off, but superchiller agitator will run continuously.

After Superchiller has cycled off, reconnect carbonator and recirculation pumps.