12
• Remove the protective plastic film from the panels. If the icemaker is exposed to the sun
or to heat, remove the film after the icemaker cools.
• Check that the refrigerant lines do not rub or touch lines or other surfaces, and that the
fan blade (if applicable) turns freely.
• Check that the compressor is snug on all mounting pads.
• The icemaker can be installed on a dispenser unit or storage bin 30" wide or wider.
The following are recommended: Hoshizaki Dispenser, Model DB-200 or DM series;
Hoshizaki Ice Storage Bin, Model B-500 series. For further options, contact your local
Hoshizaki distributor.
C. How to Remove Panels
See Fig. 1
• Front Panel: Loosen the screws. Lift up and towards you.
• Top Panel: Lift up at front slightly, push rearward, and lift off.
• Right Side Panel: Remove the screw. Slide forward slightly and lift off.
• Insulation Panel (A): Lift up slightly, and pull towards you.
• Top Insulation: Lift off.
Fig. 1
Top Panel
Front Panel
Insulation Panel (A)
Right Side Panel
Top Insulation
Side Frame
