14
2. Bin Control Installation
1) Remove the control box cover. Remove
the 2 thumbscrews securing insulation
panel (B), then remove insulation panel (B).
See Fig. 3.
2) Disconnect the discharge hose from the
pump motor, then disconnect the drain
valve drain hose and the overflow drain
hose.
3) Disconnect the pump motor connector from
the back of the control box, then disconnect
the float switch connector from the control
board.
4) Remove the tape securing the bin control.
5) Remove the 2 thumbscrews securing the
pump motor and float switch assembly. See
Fig. 4.
6) Being careful not to pull the bin control
cable, lift the bin control up out of the water
tank. Being careful not to snag the bin
control or bin control cable, slide the water
tank, cube guide, and pump motor and float
switch assembly out of the icemaker.
7) Secure the bin control to the rear interior wall using the 2 thumbscrews on the rear
interior wall. Route the bin control cable vinyl hose through the grommet as illustrated.
Do not leave any slack in the ice drop zone. See Fig. 5.
8) Replace the water tank, cube guide, and pump motor and float switch assembly in their
correct positions.
9) Secure the pump motor and float switch assembly with the 2 thumbscrews.
10) Reconnect the hoses.
11) Reconnect the pump motor connector and the float switch connector.
12) Replace insulation panel (B) in its correct position and secure with the 2 thumbscrews.
13) Replace insulation panel (A), the top insulation, the control box cover, and the exterior
panels in their correct positions.
Fig. 3
Fig. 4
Thumbscrews
Insulation
Panel (B)
Pump Motor
Connector
Float Switch
Connector (Black)
Drain Valve
Drain Hose
Overflow
Drain Hose
Discharge
Hose
Bin
Control
Tape
Thumbscrews
Water Tank
Cube Guide
Pump Motor
and Float
Switch
Assembly
Bin Control
Bin Control Cable
Fig. 5
Bin Control Cable
Vinyl Hose
Grommet
Bin Control Cable
Rear Interior Wall
Bin Control
Thumbscrews
