3
ENGLISH
1) After removing the packaging, make sure that the
icemaker and the storage bin are in good condition. If
in doubt, please do not use the icemaker but apply to
professionally qualified personnel. See the instruction
sheet attached to the storage bin for its unpacking and
installation guidelines.
2) Remove the icemaker panels to gain access to the
accessory kit and to assist easier installation.
3) Remove the package of accessories. Check the
contents according to “2. ACCESSORIES”.
4) Remove the shipping tape holding the bin control switch.
5) Remove the protective plastic film from the exterior. If the icemaker is exposed to
the sun or to heat, remove the film after the icemaker cools.
4. LOCATION
WARNING
This icemaker is not intended for outdoor use.
The icemaker should not be located next to ovens, grills or other high heat producing equipment.
This appliance is not suitable for installation in an area where a water jet could be used.
CAUTION
The location should provide a firm and level foundation for the icemaker.
NOTICE
Do not place anything on top of the icemaker or in front of the louver.
IMPORTANT
Normal operating ambient temperature should be within 1°C to 40°C. Water connection is cold water only. Operation of the
icemaker, for extended periods, outside of these normal temperature ranges may affect production capacity.
Allow the clearance specified below for proper air circulation and ease of maintenance and/or service should they be required.
Side View
(Air-cooled model)
Rear
Front
Top
ICEMAKER
30cm
30cm
Side View
(Water-cooled model)
Rear
Front
Top
ICEMAKER
15cm
15cm
In some high humidity environments, condensation may form inside the machine and drip onto the floor. Do not install where
the floor can be affected by water.
a) Front Cover: Remove the screw(s). Lift
up and pull toward you.
b) Top Panel: Remove the screw(s).
Simply lift off.
c) Side Panel: Remove the screw(s).
Slide forward slightly, and
then lift off.
d) Rear Panel: Does not require removal.
c
a
b
c
Bin Control Switch
