4
2A9584-010
Thumbscrews
Ice Chute
Fig. 8
Ice Chute
15) Place the new ice chute provided in this kit in position as shown in Fig. 8. Secure the rear of the ice chute to the
upper icemaker rear rail frame (bin control mounting bracket holes) with the new thumbscrews provided in this kit.
Secure front of the ice chute to the upper icemaker front rail frame (cube guide mounting hole) with the cube guide
thumbscrew removed in step 13. Confirm that the front of the ice chute clips over the front rail frame of the upper
icemaker and that the drain pan is not sitting on top of the ice chute.
NOTICE!
Confirm the drain pan is not sitting
on top of the new ice chute.
16) Stack the upper icemaker on top of the lower icemaker. Use of a duct jack may be required. See Fig. 9.
WARNING! Icemaker is heavy. Use care when lifting or positioning. Work in pairs when needed and use a duct
jack if available to prevent injury or damage.
17) Once in place, make the front, rear, and side panels flush to the lower icemaker. See Fig. 9.
18) At the rear of the icemakers, locate the upper and lower icemakers rear mounting holes. See Fig. 9. To prevent plastic
shavings from entering the ice storage bin area during drilling, place a large pan or cloth under the icemakers rear
mounting holes. Using the icemakers upper or lower mounting hole as a guide, drill a 3/8" (10 mm) hole down or up
through the top plastic spacer between the upper and lower icemaker. See Fig. 10.
19) Secure the upper icemaker to the lower icemaker using one of the hex bolts w/washer and nuts provided in this kit.
See Fig. 10.
Hex Bolt
w/Washer
Nut
Upper Icemaker
Lower Icemaker
Fig. 9
Fig. 10
Rear Mounting Holes
Upper Icemaker
Lower Icemaker
Flush
Ice Storage Bin
Front Rail Frame
Rear Rail Frame
Upper Icemaker
Upper Icemaker
Front Rail Frame
Ice Chute
Drain Pan
Plastic Spacer
Drill 3/8" (10 mm) Hole
Thumbscrew
