ENGLISH
12
4) Turn the unit 90 degrees on the pallet, tilt the unit
sideways, and screw in the two adjustable legs.
Note: Keep the adjusters 2 cm longer to make it
easy to pull out the pallet.
Fig. 6
Adjustable Leg
Adjuster
Leg Height
Longer Shorter
Fig. 5
5) Tilt the unit in the opposite direction, and screw
in the other two legs.
6) Slide out the pallet from under the unit.
7) For the 180 type (1800 mm wide) models only,
turn the unit sideways again, and screw in the
two legs at the center.
8) Level the refrigerator/freezer in both the left-to-
right and the front-to-rear directions. To adjust
the height of the unit, turn the adjusters of the
adjustable legs.
CAUTION
The height of the adjustable legs must be within
9 - 12 cm (or 15 - 18 cm for some models).
If extended too much, the legs may become
weak or the adjusters can come off, causing
unexpected injuries.
9) Remove the protective plastic film from the doors
and front panel.
Note: Some customized models are provided with
casters.
5. SHELF AND RAIL
[a] SHELF AND SHELF CLIP (standard)
* The shelf is adjustable in 2.5 cm increments. Adjust
the shelf clips according to the height of stored
items.
* To attach the shelf clip, insert the upper tab into
an adjust hole in the shelf post to hook the shelf
clip, and push the lower tab into another adjust
hole until it locks in place. To detach the shelf clip,
reverse the above procedure.
Fig. 7
Shelf Clip
Shelf Post
Push
Hook
CAUTION
Attach the shelf clips properly to make the
shelf level.
* To lay the shelf at the bottom of the cabinet, attach
two shelf holders each to the left and right frames
as shown below.
Fig. 8
Front
Rear
IMPORTANT
Do not put anything at the bottom of the
cabinet to prevent damage or deformation to
the cabinet bottom, resulting in corrosion.
Summary of Contents for HF-128MA
Page 13: ......
