Daily Safety Check
- It is the responsibility of the owner or caretaker of the equipment to
perform the following safety checks each day:
1. Check weatherstripping for repairs or replacements. Make sure weatherstripping
does not "hang off" the wing because this could create a tripping hazard.
2. Check for general cleanliness in and around the door. Remove debris that may
have accumulated under the wings or around the enclosure.
3. Check for broken, cracked glass panels. There should be no bulletin boards,
literature racks, merchandise displays, or other attractions in the door area.
Any of these items could impede the flow and vision of pedestrian traffic in the
revolving door.
4. If floor mats are used inspect the mat condition and the floor surface. The area
underneath the mat should be clean and free of debris. The edges of the mat
should lay flat against the floor surface.
Maximum Speed Recommendations for Speed Control -
To comply with any of the
four building codes NFPA 101, Uniform Building Code, Basic Building Code, Standard
Building Code, door speeds must be adjusted on the speed control to or below the
maximum speeds listed below.
Inside Diameter
RPM
6’-0” (1830mm)
12
6’-6” (1980mm)
12
7’-0” (2133mm)
11
8’-0” (2440mm)
10
Limited Warranty and Related Information
Horton Automatics (Seller) warrants to the Buyer all products they manufacture to be free
from defects in material and workmanship, under normal use and service, for twelve months
from the date product is placed in operation. The Seller’s obligation under this warranty is
limited to the repair or replacement at the factory, of any parts which shall be returned to the
Seller with transportation charges prepaid and which after examination, prove to be
defective. Said warranty shall not apply to such products which shall have been installed,
altered, or repaired by any person not expressly authorized in writing for such purpose by
the Seller, or subjected to misuse, negligence or accident. The aforesaid warranty is made
expressly in lieu of other warranties, expressed or implied and in lieu of any other
obligations or liabilities on the part of the Seller and the Seller neither assumes nor
authorizes any person to assume for it any other liability or obligations in connection with the
sale of such products to the Buyer.
There is no warranty of merchantability or fitness for any particular purpose, nor is
there any warranty, expressed or implied, except as specifically stated above. seller
shall not be liable for special or consequential damage, nor for claims of any third
party against the buyer.
Generally, the installing distributor provides a one-year warranty covering the labor and
transportation charges for defective parts replacement. If this is the customer’s wish, it
should be specified.
3
