background image

Please follow these instructions exactly as directed on this page and shown on page 3. Failure to follow these assem-

bly instructions correctly may result in a non functional lamp or unsafe lamp (see saftey information). 

We encourage you to also watch this video guide for assembly of this light: www.youtube.com/watch?v=8EIbC1E2U4o

Marterials: 2x long screws/ 8x short screws/ 2x nuts/ 1x straight connector/ 4x plastic screw legs. 

Tools:

Before starting, you will need the following: 

Wire stripper and included philips screwdriver.

Step 1:   Hand tighten all four legs into the four outermost screw holes on the heatsink.

Step 2:   Place LED board on heatsink, matching all the screw holes.

Step 3:   Screw all short screws from kit bag into the LED board holes marked in red  using the included screwdriver.

Step 4:   Flip heat sync, placing it on its previously installed legs. The “fins” side of the heatsink should be face up.

Step 5:   Place the ‘HLG-120H-54A’ driver diagonally across the “fins” with the red/black wire side towards the two 

 

 largest holes on the edge of the heatsink.

Step 6:   Line up the heatsink and driver holes.

Step 7:    Screw the two long screws in from the non-finned side of the heatsink on both sides then tighten the two nuts onto  

 

 them.

Step 8:   Strip ALL but 3-4 inches of the outer sleeve that is holding the two red and black sleeved wires with the wire stripper.

Step 9:    Insert the red and black wires through the large holes accordingly. BLACK to NEGATIVE and RED to POSITIVE,  then push  

 

  the wires into the connectors until they lock in place.

Step 10:   Cut about a quarter inch from the top of the opposite side wires and then strip them as shown in diagram, otherwise it is  

 

   possible that the wires could hang out of the clamp when tightened.

Step 11:   Insert the wires into one side of the straight connector EXACTLY as instructed;  BLUE wire to SILVER coated hole. GREEN/ 

 

 YELLOW wire to COPPER coated hole. BROWN wire to BLACK coated hole and screw them in using the included screw-

driver.    

 

Do not

 over tighten screws, as it can cut the wires.

Step 12:   Insert plugin cord wires into the other side of the straight connector EXACTLY as instructed; WHITE wire to SILVER coat- 

 

  ed hole. GREEN wire to COPPER coated hole. BLACK wire to BLACK coated hole. Screw them in using the included  

 

  screwdriver. 

Do not

 over tighten screws, as it can cut the wires.

Step 13:   Tighten the caps to the straight connector.

Step 14:   Plug it in and shield your eyes!

135 KIT ASSEMBLY

Step 1:

Step 2 & 3:

Step 4 & 5:

Step 6 & 7:

Step 8:

Step 9:

Step 9 (2):

Step 10:

Step 11:

Step 12:

Step 13:

Page 3

Page 2

Reviews: