horsch Shuttle 8.000 L, Operating Instructions Manual

Page: 49 / 65

High pressure cleaner
NOTE
Do not clean new machines with a steam jet
or high pressure cleaner.
The paint takes approx. 3 months to cure and
could be damaged before this time.
Remember the following points when cleaning
with a high pressure cleaner/steam jet:
¾
Do not clean any electrical components.
¾
Do not clean any chrome-plated components.
¾
Before cleaning the machine cover all open-
ings, which should stay clear of water, steam
or cleaning agents for reasons of safety or
functioning.
¾
Do not aim the water jet directly at electrical
or electronic components and bearings.
¾
Do not direct the cleaning jet of the high pres-
sure cleaner/steam jet directly on lubrication
points and bearings, lines and stickers.
¾
Always keep a minimum distance of 300 mm
between cleaning nozzle and machine.
¾
Avoid the use of dirt removing tools on the
high pressure cleaner, if necessary, keep a
greater distance.
¾
Pay attention to the safety regulations when
using high pressure cleaners.
CAUTION
Risk of fluids escaping under pressure.
The external cleaning system may be contami-
nated with spraying mixture deposits!
Secure the washing gun with the lock against
accidental spraying:
¾
before each spraying pause
¾
before the washing gun is stored again in its
holder after cleaning is finished.
The Shuttle is equipped with a high pressure
cleaner (optional) that can be used to clean the
machine.
The high pressure cleaner is powered hydrauli-
cally and supplied from the fresh water tank
(Tank 2).
1
2
3
High pressure cleaner
1 Hose reel
2 Pressure hose
3 Washing gun
1. Close valve 3 .
2. Open valve 4 .
3. Turn the lever 6 down to high pressure cleaner .
Water is suctioned from the fresh water tank.
4. Pull the pressure hose off the reel and clean
the machine with the washing gun.
¾
Water escapes from the washing gun as
long as the handle is pressed.
¾
To fix the handle actuation press the tappet
during operation.
¾
Press the handle to release.
¾
After switching off relieve the residual
pressure.
5. After cleaning is completed, turn lever 6 to
the centre position to turn off the pump again.
6. Close valve 4 .
7. Wind up the pressure hose again on the reel
and place the washing gun on the bracket.
45