horsch Joker RT Series, Owner'S Manual

Page: 27 / 50

27 | P a g e
Transport
Depending on country specific regulations and working width, the equipment can be transported on
public roads, either attached to a tractor or on a trailer or low loader.
• The permissible dimensions and weights for transport must be complied with.
• The tractor must be big enough, so that sufficient steering and braking abilities are assured.
• If the machine is hitched up in two-point mode, the tractor link arms must be blocked against swinging
sideways.
• For road transport insert the provided yellow safety stops and wing locks pins inserted where
necessary). NOTE: Do NOT rest the machine on the safety stops. The machine has a load hold
valve in the circuit to hold the cylinder when it is disconnected from the tractor . The yellow safety
stops are primarily a safety device in case of a failure in the hydraulic circuit and used during
service of the machine. The machine is transported on the rear tires of the transport axle. Never
transport the machine on the rear Roll-Flex packer system.
• On a trailer or low loader, the machine must be secured with tensioning straps, chain binders, or other
means.
• Attach lifting tackle only at the specially marked hoisting/lifting points.
DO NOT EXCEED A MAXIMUM TRANSPORTATION SPEED OF 20 MPH (32 KPH) DURING
TRANSPORTATION. LOSS OF VEHICLE/MACHINE CONTROL CAN RESULT IN SERIOUS PERSONAL INJURY
OR DEATH!
Front Hitch decal