6
© 2001 Directed Electronics, Inc. Vista, CA
H1/6 RED (+)12V CONSTANT POWER INPUT
Before connecting this wire, remove the supplied fuse. Connect to the battery positive terminal or to the (+) 12V
feed for the dome light circuit.
NOTE:
Always use a fuse within 12 inches of the point you obtain (+) 12V. Do not use the 10A fuse
in the harness for this purpose. This fuse protects the module.
transmitter/receiver learn routine
This system uses a microprocessor-based learn routine to program and store transmitters in memory. Up to four
transmitters are retained in memory, even if the unit is disconnected from the vehicle battery.
To enter the transmitter/receiver learn routine:
1.
Power up the system by placing the fuse in the fuse holder. If the system is already powered
up, it must be powered down and back up before it will enter the transmitter/receiver learn
routine.
2.
Within five seconds, press Button I on the first transmitter. The siren will chirp once.
3.
Within five seconds, press Button I on the first transmitter again. The siren will chirp twice.
4.
Within five seconds, press Button I on the first transmitter a third time. The unit will gen-
erate one long chirp.
5.
Repeat steps 2 through 4 for all transmitters to be learned. The system will learn up to four
transmitters using the learn routine procedure.
The transmitter/receiver learn routine will automatically be exited if five seconds elapse without the unit
receiving a transmitter code. The system will generate one short chirp followed by a long chirp when the learn
routine is exited.
