© 2001 Directed Electronics, Inc. Vista, CA
3
what is included
■
One control module with on-board shock sensor
■
One plug-in status LED
■
One plug-in Valet/program switch
■
One 12-pin primary harness (H1)
■
One 5-pin auxiliary harness (H2)
■
One Revenger Soft-Chirp siren
installation points to remember
■
Check with the customer on Status LED location.
■
Use seat and fender covers to protect the vehicle.
■
Remove the domelight fuse. This prevents accidentally draining the battery.
■
Roll down a window to avoid being locked out of the car.
■
Do not disconnect the battery if the vehicle has an anti-theft coded radio. If equipped with an air bag, avoid
disconnecting the battery if possible.
■
Remove necessary under-dash trim panels to provide access for mounting the system’s components.
IMPORTANT!
Please read this entire installation guide before beginning the installation. The instal-
lation of this security system requires interfacing with many of the vehicle’s systems. Many new
vehicles use low-voltage or multiplexed systems which can be damaged by low resistance testing
devices, such as test lights or logic probes. Test all circuits with a high-quality digital multi-meter
before making the connections.
IMPORTANT!
Many airbag systems display a diagnostic code through their warning light after they lose
power. Disconnecting the battery requires this code to be erased, which can require a trip to the dealer.
■
Test all functions. The “Using Your System” section of the Owner’s Guide is very helpful when testing.
■
When testing, don’t forget that this system is equipped with Nuisance Prevention Circuitry (NPC). This cir-
cuitry can bypass both instant trigger zones, making them appear not to work.
■
Carefully reassemble the under-dash trim panels.
■
Inspect the engine compartment for tools that may have been left behind.
after the installation
before beginning the installation
