59 South State Ave., Indianapolis, IN 46201 | (p) 317.916.4274 (tf) 877.665.5666 (f) 317.639.4279 | www.hornerlighting.com
LMAN0042-02-EN
Fixture Mounting
Mount the silver mounting plate to the building using proper anchors for the building material. You may need to add
additional support behind the surface material. The front portion of the fixture can be removed for easer mounting. Attach
the base of the fixture to the mounting plate by hooking the top of the fixture first then tighten the Allen set screws to secure
the fixture. The set screws should be tightened to 5 to 10 in-lbs.
Wiring
Make all electrical connections in accordance with the National Electrical Code and any applicable local code requirements.
Verify that supply voltage is correct by comparing with the National Electrical code and any applicable local code
requirements.
If wiring to the supplied lead, connect the lead to matching color code only. Note: Do not touch the yellow LED light source.
The service wire for the fixture should enter using one of the three 1/2
”
conduit points on the fixture. Be sure to make
proper water tight conduit connections that follow your local code.
Once wiring is complete, re-attach the front portion, make sure the gasket is properly aligned and tighten the fixture
screws to 10 inch-lbs.
Now you can re-apply power to the circuit and verify operation.
Cleaning
To maintain efficiency, the glass lens should be cleaned with a mild soap or neutral PH cleaner. Do not touch the yellow LED
light source.
Abrasives or cleaners containing chlorinated or aromatic hydrocarbons should not be used. Once clean, rinse with cold
water and wipe dry with a soft cloth.
Technical Support
Tel: 317-916-4274
Fax: 317-639-4279
Email: [email protected]
Web: http://www.hornerlighting.com
