Hornbach J.C. Schwarz JWS1400XE, Manual

Page: 105 / 108

EN 105
INSTALL WHEEL
THICKNESS: < 4 MM
Install straight grinding wheels with the
lock nut 4 so that the flange points away
from the machine.
Press and hold the spindle lock button 2
and tighten the lock nut 4 with the wrench.
1
Remove the 3 screws from the guard lock
latch 3 , by use of a 3 mm allen wrench.
2
The operation speed can be set in six
steps from:
1 = 6500/min - 6 = 12000/min
CHANGE GUARD
Remove the cutting wheel and the lower
flange 11 .
1
ADJUST GUARD
Pull up the grinding guard 10 at it’s very
end until it disengages from the guard
lock latch 3 .
1
SPEED DIAL
Use the speed dial 6 to set the operation
speed.
1
Rotate the grinding guard 10 into the
desired position. Make sure that the
guard lock latch 3 is engaged.
2
THICKNESS: ≥ 4 MM
Install depressed grinding wheels with
the lock nut 4 so that the flange points
towards the machine.
Press and hold the spindle lock button 2
and tighten the lock nut 4 with the wrench.
2
Install the cutting guard (accessory) by
use of the guard lock latch 3 and the three
screws.
Reinstall the lower flange 11 and install a
cutting wheel.
4
Remove the grinding guard 10 from the
tool.
3
Warning! Make sure the tool is
switched off and unplugged.
Warning! Make sure the tool is
switched off and unplugged.
Caution! Pay attention not to block the
tool at low speed.
Warning! The guard shall be oriented
to protect the auxiliary handle.