QUICK START
• Verify unit is properly assembled with scale plate, powder pan, and clear powder
hopper in place.
• Turn unit on by removing the powder pan, plugging it in and pressing black power
button on front of unit. For best performance, allow unit to stabilize for 5-15
minutes before use.
• Calibration is recommended before each use. (See Calibration Section.)
• Ensure powder pan is on scale and that actual weight reading (right side of
display) reads
“0.0.”
If not, touch
ZERO/CALIBRATE
button.
• Verify that powder hopper empty nozzle (at rear, right side) is closed. Fill clear
powder hopper until powder is visible at bottom of clear hopper. Fill higher if
loading many rounds.
• Check to be sure that “Setting” reads “Normal.”
• Tap
TARGET
button in upper left corner.
• Enter Target Weight using numerical keypad. Last number entered should be
decimal amount of charge:
xx.X.
Press
ENTER
to store Target Weight.
• Tap
DISPENSE
to begin dispensing entered powder charge.
• Should dispensed charge be greater than 0.1 of a grain above targeted amount,
“OVER”
will be displayed. Press
ENTER
to remove
“OVER”
warning. Then, either
dump charge into powder tube and re-dispense or remove a small amount of
powder, and press and hold
DISPENSE
to trickle to desired weight.
• Do not use
“OVER”
charges.
3
