Lock Tabs
Scanner
Key Pad
5
Battery Power Mode
When the Biometric Safe is unplugged,
and is operating on battery power,
you
must press any button on the lid to
activate the reader.
Pressing any
button on the lid
causes
the system to go from battery saving
mode to ready status.
For example:
To open your safe with the
fingerprint scanner while the system
is running on battery power, first press
any
button on the lid
to bring it to ready
status. Then slowly slide finger across
the fingerprint scanner to open the safe.
Keypad Tones On/Off
Press and hold the “1” button on the
keypad for 5 seconds until the light turns
off to toggle sound on and off.
To check battery level:
1. Disconnect from AC power source.
2. Press and release any button
on the lid.
3. The LED light below the fingerprint
scanner will flash.
a. Flashing Green – Good battery
b. Flashing Yellow – Low battery
c. Flashing Red – Dead battery
4. After 10 seconds the safe will
return to normal operation.
NOTE:
Replace batteries every twelve
months or if they become weak.
