Power Jack
Stop Catches
Foam
Power Jack
4
Batteries
For backup or mobile use, your safe
requires four AA batteries (not included).
To install batteries, remove inner foam
from base and verify AC adapter is
unplugged. Press down on the two lock
tabs and rotate door forward on the
battery compartment. Only use new
high quality AA batteries. Replace all
batteries at the same time.
AC Power
The Biometric Safe is designed to
be powered by either the AC power
supply or four AA batteries.
To connect the AC power supply,
first open the safe with the circular
key, and then press in the lid’s stop
catches to fully extend the lid for
easy access. Remove the foam from
the lower compartment, and insert
the power jack through the square
hole in the bottom of the safe. With
the battery door closed, plug the
AC power supply into the back of
the front panel. The cord should be
routed to the left side of the safe
before reinserting the foam.
Biometric Safe Setup and Operation
Congratulations on purchasing the technologically advanced Biometric Safe.
You have taken a significant step in securing the safety of your handgun.
To achieve the best experience with your Biometric Safe, please read all
instructions carefully, and understand its operation.
After the Biometric Safe has been taken out of the box, please check to be
sure both circular barrel keys fit and unlock your Biometric Safe. Contact
Hornady
®
at 800-338-3220 if the keys do not work. Store keys in a secure
location outside the safe.
