Horizon Reverse Osmosis Seafari Escape 200, Owner'S Manual

Page: 59 / 126

MCC 2, or SRC MCC 3 (only one chemical as appropriate for the type of cleaning desired). DO
NOT ADD ANY OTHER CHEMICAL. DO NOT MIX MORE THAN ONE CHEMICAL TO THE
WATER.
11. Mix and thoroughly dissolve the solution in the Rinse/Clean Solution Container.
12. Configure the System for a “RO Membrane Element Cleaning Closed Loop.”
13. Disconnect the brine discharge line from the brine discharge tee and place it into the storage/cleaning
container.
14. If the Clean/Rinse Outlet Valve is installed, position it to return to the storage/cleaning container.
15. Operate the system by pressing the “START/STOP” switch. The membrane cleaning solution flows
from the container through the system and back into the container in a closed loop configuration.
16. After approximately one hour of circulation, stop the system by pressing the “START/STOP” switch
twice, which will also disable the freshwater flush cycle.
17. Discard the cleaning chemical solution in a safe, environmentally friendly and legal manner.
18. To closed loop rinse the cleaning chemical from the system, again fill the Rinse/Clean Solution
Container or bucket with 5 gallons of non-chlorinated product water.
19. Operate the system by pressing the “START/STOP” switch. The rinse water flows from the container
through the system and back into the container in a closed loop configuration.
20. After approximately 15 minutes of circulation, stop the system by pressing the “START/STOP”
switch twice, which will also disable the freshwater flush cycle.
21. Discard the rinse water in a safe, environmentally friendly and legal manner.
22. Perform a final rinse. Reconfigure the system for a “ONCE-THROUGH DEPRESSURIZED RINSE”.
23. Reconnect the brine discharge line to the brine discharge tee.
24. If the Clean/Rinse Outlet Valve is installed, position it to discharge out toward the brine discharge
connector.
25. One final time, fill the Rinse/Clean Solution Container with non-chlorinated product water.
26. Start the system. The rinse water rinses the entire system and discharge to waste.
27. Just prior to depleting the rinse water from the Rinse/Clean Solution Container, stop the system
by pressing the “START/STOP” switch once to initiate the Automated Freshwater Flush Cycle every
7 days. Press the “START/STOP” switch twice to abort the Automated Freshwater Flush Cycle.
28. Reconfigure the system for normal operation:
a) Reconnect the Sea Strainer outlet line or reposition the Inlet Rinse/Clean Valve to normal
operation position.
b) Remove the Product Relief Tube Kit.
c) Reconnect the High-Pressure Hose.
The system may now be operated or left unattended for up to 4 to 8 weeks, refer to the short-term
storage procedures. If the system will be stored without use for longer than 8 weeks, refer to the
long-term storage procedures to winterize the system. If the system will be stored in freezing
temperatures refer to short-term storage procedures or long-term storage procedures, as appropriate,
to winterize the system.
59
System Storage and Cleaning