3
•
Always operate your model in an open area away from
people and cars. The potential speed of this model can
cause injury or damage.
•
Never operate your Ten-T with low transmitter or receiver
batteries – especially AA dry cells as control and power will
be limited.
•
Repeated or prolonged use of heavy braking will cause the
brakes to overheat and fail! Always leave plenty of room
for stopping.
•
It will take as much room to stop as it does to accelerate to
speed. Always run in an open area with plenty of braking
room.
Special Warnings about the LiPo battery
used in this model:
While the 2S 7.4V 1000mAh Lithium Polymer Battery
(LOSB9818) included with your Ten-T features Charge
Protection Circuitry and optional Balance Charging you MUST
read the following safety instructions and warnings before
handling, charging or using this LiPo battery. Always follow the
manufacturer’s instructions when disposing of Lithium Polymer
batteries.
Note: Lithium Polymer batteries are significantly
more volatile than the alkaline, NiCd or NiMH
batteries used in RC applications. All instructions and
warnings must be followed exactly. Mishandling of
LiPo batteries can result in fire. By handling, charging
or using the included LiPo battery you assume all
risks associated with lithium batteries. If you do not
agree with these conditions, return your complete
Ten-T model in new, unused condition to the place of
purchase immediately.
•
Never let the LiPo receiver battery discharge completely –
you can monitor this on the radio screen. When you see it
is getting low stop and recharge. Failure to do so will ruin
the battery and it cannot be recharged.
•
You must charge the included 2S 7.4V 1000mAh LiPo
battery in a safe area away from flammable materials. The
LOSB9700 LiPo Protection Pouch is suggested.
•
Do not charge the battery when installed in the model.
•
Never charge the battery unattended. When charging you
should always remain in constant observation and be able
to react to potential problems that may occur.
•
Keep hobby knives and sharp objects away from LiPo
batteries. Puncturing will cause damage and can result in
fire.
•
After use, the battery must be cooled to ambient air
temperature before charging.
•
You MUST use a LiPo specific charger similar to the one
included with the Ten-T. Failure to do so may result in a fire
causing personal injury and/or property damage.
•
DO NOT USE AN NiMH/NiCd charger under any
circumstance.
•
Always follow the charging directions and never charge at
more than 1 amp. Failure to do so could result in a fire.
•
If at any time during the charge or discharge process
the battery begins to balloon or swell, stop charging or
discharging immediately. Quickly and safely disconnect
the battery and place it in a safe open area away from
flammable materials to observe it for at least 15 minutes.
Continuing to charge or discharge a battery that has
begun to balloon or swell can result in a fire. A battery that
has ballooned or swollen even a small amount must be
removed from service and disposed of safely.
•
Store the battery at room temperature with no less than
½ charge (3.7V per cell; 7.4V for a 2S battery pack) for best
results. Never store the battery discharged.
•
When transporting or temporarily storing the battery,
the temperature range should be from 40–120 degrees
Fahrenheit. Do not store the battery or model in a car or
direct sunlight. If stored in a hot car, the battery can be
damaged or even catch fire.
•
Although the battery included with the Ten-T has a low
voltage circuit included which prevents over-discharging
the battery, you should never discharge the battery below
6.1V during use (3V per cell).
•
The included battery also uses a 25-amp draw protection
cutoff that occurs when the battery is under load. If this
occurs you must correct the reason for the high current
draw (usually the starter motor being stalled) and reset the
cutoff by turning the receiver in the model “Off” then “On”
again.
•
Always be careful to observe the proper polarity when
charging or using the battery.
•
Be careful not to short the output or balance leads.
•
Do not ever try to disassemble the pack.
•
For best performance balance the pack periodically.
•
If you have any further questions or concerns regarding
the handling, charging and/or use of the included LiPo
battery pack, please contact Horizon Hobby’s Product
Support staff. Contact information can be found in the
warranty section of this manual.