5
EN
Fun Scale PT-19 PNP
JOINING THE WING PANELS
11.
Slide the wing tube into the socket in the wing. It will slide in
easily, do not force it in farther than it will easily slide.
Optional
10.
Use a fl exible silicone adhesive to attach the landing gear
fairings to the landing gear. Use low-tack tape to hold the
fairings in position until the adhesive fully cures.
12.
Slide the remaining wing panel on the wing tube. The wing
panels will fi t together tightly and with no gaps.
STABILIZER AND FIN INSTALLATION
13.
Remove the canopy hatch from the fuselage by sliding the
latch located in the rear cockpit forward.
14.
Lift the hatch at the rear and remove it from the fuselage. Set
it aside in a safe location.
LANDING GEAR INSTALLATION
6.
Fit the landing gear wire into the wing. The landing gear will
angle forward when installed correctly. The wire will be fl ush
with the bottom of the wing when installed.
7.
Secure the landing gear uisng two nylon landing gear straps
and four 3mm x 12 self-tapping screws. Thread the screws
into the predrilled holes, then use a #2 Phillips screwdriver to
tighten the screws.
8.
Slide a wheel collar on the landing gear. Thread an M3 x 4mm
setscrew into the wheel collar. Use the supplied hex wrench
to tighten the setscrew on the fl at area on the landing gear
nearest the vertical leg.
9.
Slide the wheel on the landing gear, then secure it using a
wheel collar and M3 x 4mm setscrew.
Optional
: Use a small amount of threadlock on
each setscrew to prevent them vibrating loose.
