EN
Carbon-Z Cessna 150T 2.1m
12
Main Gear Installation
1. Place the two main landing gear halves
(A)
into the pocket on the bottom
of the fuselage.
2. Secure them into place using the mounting plate
(B)
and 6 included
M3 x 18mm screws
(C)
. Tighten the M3 x 18mm screws using a 2.0 hex
wrench.
When needed, disassemble in reverse order.
Nose Gear Installation
1. Remove the battery hatch
(D)
to access the location where the nose assembly
screws will be installed.
2. Connect the nose gear pushrod
(E)
to the nose gear steering arm
(F)
using the
included nut and bolt as shown. Tighten the M2 lock nut and M2 x 8mm screw
using a 5mm nut driver and a 2.0 hex wrench. Part of the box surrounding the
steering arm has been removed to show the steering arm.
3. Remove the pushrod retainer
(G)
at the end of the nose gear pushrod and
install the nose gear assembly into the fuselage leading with the pushrod.
4. Use the arrows on the bottom of the main mount to install the nose gear in the
correct direction. The arrows point to the front.
5. Guide the pushrod into the fuselage to meet with the servo horn.
6. Secure the nose gear assembly into place using the two M3 x 12mm screws
(H).
Tighten the M3 x 12mm screw using a 2.0 hex wrench.
Continue nose gear installation on next page.
G
D
H
M3 X 12mm
E
F
M2 lock nut
M2 x 8mm
A
B
C
M3 X 18mm
Optional Tricycle Gear Installation (Sold Separately)
