EN
Carbon-Z Cessna 150T 2.1m
10
Main Wing Installation
1. Secure each wing strut to the wing using the included M2.5 nut
(A)
and
M2.5 x 20mm bolt
(B)
. Tighten the M2 nut and M2.5 x 20mm screw using a
5mm nut driver and a 2.0 hex wrench. Note the orientation of the fuselage end
of the strut. The strut should be oriented as shown in the illustration.
2. Slide the wing tube (
C
) into the fuselage.
3. Align the wing halves
(D)
with the recess of the fuselage and fit the wing
to the fuselage.
4. Align the wing struts
(E)
to each side of the fuselage and secure them into
place with the pin
(F)
and R-clip
(G)
.
5. Secure both wing halves into place using the two thumb screws
(H)
. Install
them from the inside of the fuselage going out into the wing.
6. Re-install the top hatch.
When needed, disassemble in reverse order.
C
H
B
M2.5 x 20mm
B
tooltip
G
R-clip
E
F
A
M2.5 nut
YES
NO
D
