EN
Model Assembly
Continued
Control Surface Centering
Control Surface Centering
After assembly and transmitter setup, confi rm that the control surfaces are
centered. If the control surfaces are not centered, mechanically center the
control surfaces by adjusting the linkages.
If adjustment is required, turn the ball link on the linkage to change the
length of the linkage between the servo arm and the control horn.
After binding a transmitter to the aircraft receiver, set the trims
and sub-trims to 0, then adjust the ball links to center the control surfaces.
• Turn the linkage
clockwise or
counterclockwise until
the control surface is
centered.
• Attach the linkage to
the servo arm or control
horn after adjustment.
Scale Antenna Installation
Install the scale antenna
(I)
by pushing them into place.
I
9
