EN
10
ST. REV
TH. REV
AFTER DRIVING
When you are finished driving your vehicle:
1. Power off the vehicle.
2. Power off the transmitter.
3. Remove the vehicle battery
and charge if necessary.
BINDING THE TRANSMITTER AND RECEIVER
Bind Button
Binding is the process of programming the receiver to recognize a specific transmitter signal, thus preventing interference
from other transmitters. The transmitter and receiver included with your vehicle are bound at the factory. If you need to
rebind, follow the instructions below.
NOTICE:
Do not attempt to bind the transmitter and reciever if any other compatible transmitters are in bind mode
within approximately 400 feet (120 meters). Doing so may result in unexpected binding to the wrong transmitter and
loss of control of your vehicle.
Prior to starting the binding procedure, ensure the servos and motor are connected to the proper ports on the receiver
and the transmitter has fresh batteries installed.
Always place the transmitter in bind mode first, followed by the receiver.
1. Power on the transmitter while holding the bind button. The G LED will flash rapidly.
2. Release the bind button.
3. Power on the receiver. The receiver will enter bind mode after approximately one second.
When binding is successful the LED on the receiver will glow continuously and the G LED on the transmitter will go off.