EN
6
Installing the Flight Battery
Wing Installation
1. Make sure the throttle is in the off position (0%)
and then turn on the transmitter.
2. Remove the canopy from the aircraft.
3. Plug in the flight battery.
4. Install the flight battery into the aircraft as shown
and close the canopy.
1. Carefully slide the wing into the fuselage as
shown.
2. Continue sliding until the wing locks into place.
3. The wing can be removed for storage by simply
pulling it back out.
Tip:
Firmly grasp the wing at the root (close to
the center) and not out at the tips.
3
2
4
1
CAUTION:
Always disconnect the flight
battery from the aircraft when not flying to avoid
over-discharging the battery. Batteries
discharged to a voltage lower than the lowest
approved voltage may become damaged,
resulting in loss of performance and potential fire
when batteries are charged.
CAUTION:
Keep away from the propellers.
Arming the Aircraft
1. Move the throttle stick from power off (0%) to full
throttle (100%) and back to power off.
2. The red LED will change from flashing to solid
when arming is complete.
