Step
5
10
Tail Control Test
1. Be sure the throttle slider is in the
Off position.
2. Switch on the transmitter—check to make
sure the LED is lit, indicating the trans-
mitter has power.
3. Install battery in fuselage and plug in
connector.
4. Move the stick side to side. The tail
control surfaces should move as shown
on the following page.
5. Move the stick up and down. The tail
control surfaces should move as shown
on the following page.
6. The small levers under and to the side
of the control stick are the trim levers
and are used to adjust the “neutral”
point of your control stick. It’s very
important that this lever is centered
when performing these control tests.
7. If each control surface is not level with the
rest of the tail surface when the trim levers
are centered, adjust the control surfaces
so they are level (see page 12).
Warning:
Keep everything clear of the
propeller before starting the control test
in the event that you accidentally turn on
the motor.
Elevator
Trim Lever
Rudder
Trim Lever
Summary of Contents for AerBird3
Page 1: ...Instruction Manual...
