4
WARNING:
Before using the VersaBALL FX
TM
please read the following safety instructions to
reduce the risk of injury.
1. Read all warning labels attached to VersaBALL FX.
TM
2. Read the Assembly/Owner's Manual in its entirety.
3. Make sure the VersaBALL FX
TM
is assembled properly before using, tightening all hardware.
4. Do not allow children to play on VersaBALL FX.
TM
5. Keep pets away from VersaBALL FX.
TM
6. Keep ball away from sharp objects and inspect ball before each use for any areas where ball
may be damaged; this includes deep scratches or gouges.
7. Keep resistance bands away from rough surfaces and inspect bands before each use for any
areas where resistance bands may be damaged; this includes cuts, deep scratches, or gouges.
8. There are non-slip pads on the base of the VersaBALL FX,
TM
please make sure they are in contact
with the floor. A fitness mat also helps stabilize the product.
9. Consult a physician before exercising on the VersaBALL FX.
TM
If at anytime while working out on
the product you feel discomfort, stop and consult your physician.
10. Choose exercises that fit your level of fitness experience, considering your strength and flexibility
during all exercises.
11. Wear proper fitness clothing; clothing that does not hang over machine.
12. Try to maintain balance at all times when using the VersaBALL FX.
TM
Falling from the machine may
result in serious bodily injury.
13. The VersaBALL FX
TM
should only be used by one person.
14. The VersaBALL FX
TM
is not intended for commercial use. It should not be used in health clubs,
hospitality corporations, medical corporations, or any other business not selling to the end-
consumer.
WARNING:
Before starting an exercise program consult a physician. This is very important if you
have never exercised before, you are pregnant, or you suffer from any illness making physical activi-
ties more difficult.
Safety Instructions
11
Assembly Instructions
STEP 7
Assemble handle bar to upper ball ring. The left and
right handle tubes, as well as the rear handle tube,
should slide over the upper ball ring male tube ends.
Use 3 Bolt D’s and 3 curved washers.
BOLT D
STEP 8
Inflate the ball.
WARNING...DO NOT OVER-INFLATE!
To ensure your ball is inflated properly you will need to measure the distance between the ball and
the seat when the seat is at a mid-level position. There should be a 1/2 inch of space between the
seat and the ball so that the seat can move up and down properly.
.5”
VersaBALL_User’s_Guide_v1.9.qxd 10/7/2004 2:55 PM Page 5
