Horizon Fitness LIMITED SERIES E6050, User Manual

Page: 8 / 32

8
Assembly
UNPACKING
Unpack the product where you will be using it. Place the product on a level flat surface. It is recom-
mended that you place a protective covering on your floor.
Note: It is recommended that you apply
grease to the threads of each bolt as you assemble the product, to prevent loosening and noise. Also,
during each assembly step, ensure that ALL nuts and bolts are in place and partially threaded in
before completely tightening any ONE bolt.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN INJURY! Place your elliptical
trainer on a level flat surface. It is recommended that you place a protective covering on your floor.
Parts (see illustration on previous page)
• 1 Front Foot Tube
• 2 Upper Handlebars
• 2 Lower Handlebars/Link Arms
• 2 Pedal arms
• 2 Guide Rails
• 1 Console Mast
• 1 Console Mast Boot
• 1 Power Supply
• 2 Pedal Arm Sleeves
• 2 Crank Boots
• 2 Front Upper
Handlebar Covers
• 2 Back Upper
Handlebar Covers
• 1 Hardware Pack
(contents listed below)
Tools (included)
•
4mm Allen Wrench
• 5mm Allen Wrench/
Phillips Screw Driver
• 13/15mm Flat Wrench
• 17mm Wrench
CONTACT HORIZON FITNESS CUSTOMER ASSISTANCE CENTER; TOLL FREE @ 1-800-244-4192
OR VISIT www.horizonfitness.com