6
NOTE:
Make sure the plug is inserted all the way into the power connector or else damage to the power adapter may result.
Do not use an adapter of more than 9 volts at 500 milliamperes or damage to the TR-100 may result.
4.2 Connecting LTC In and Out
Figure 4-1 shows a basic hookup for the TR-100.
VCR
TR-100
IN LTC
LTC OUT
LTC OUT
As Required
MIDI Out
As Required
Figure 4-1, Basic TR-100 Hookup
Connect SMPTE LTC from its source to the RCA connector labeled LTC IN. Reshaped, 2V P-P LTC is available at
the RCA connector labeled LTC OUT.
4.3 Connecting MIDI Out
Use a standard 5-pin DIN MIDI cable to connect the TR-100 MIDI time code output to your MIDI equipment as
desired.
5
OPERATING THE TR-100
5.1 Controlling the Display
The TR-100 rear panel DATA switch allows the display of either time code or user bits.
The FRAMES switch allows the frame number display to be turned on or off. This only applies when displaying
time code. When user bits are displayed, the FRAMES switch is disabled.
The BRIGHT knob controls the display brightness.
5.2 Display Description
The following paragraphs refer to Figure 5-1 when describing various aspects of the TR-100 display.
DF
12:35:23:09
12:35:23:09
HRS
MIN
SEC
FRM
LTC PRESENT
Figure 5-1, TR-100 LED Display