！
WARNING:
The 594810 is not defibrillator-proof. However, it may
remain attached to the patient throughout defibrillation or while an
electrosurgical unit is in use, but the measurements may be inaccurate
throughout the defibrillation and shortly thereafter.
！
WARNING:
Use only the SPO2 sensor and extension cable supplied by
Hopkins Medical Products. Do not connect any device other than a
Hopkins-approved SPO2 sensor to the sensor connector.
！
WARNING:
The 594810 should not be used adjacent to or stacked with
other equipment. If adjacent or stacked use is necessary, the 594810
should be observed to verify normal operation using the configuration
in which it is to be used.
！
The medical electrical equipment needs to be installed and put into
service according to EMC Information
！
The use of patient cable and other accessories not supplied by the
manufacturer may result in increased emissions or decreased
immunity of the equipment
！
The equipment should not be used adjacent to or stacked with other
equipment, refer to the recommended separation distances provided in
EMC Information
CAUTION
！
！
Caution:
Federal law (U.S.A.) restricts this device to sale by or on the
order of a physician.
！
Caution:
All combinations of equipment must be in compliance with
IEC Standard 60601-1-1 systems requirements.
！
Portable and mobile RF communications equipment can affect medical
electrical equipment, refer to the recommended separation distances
provided in EMC Information
-7-
