Cleaning final filter
The
final filter
assists in the filtra-
tion process to return clean air to
the room.
To remove this filter when it be-
comes dirty, remove bag door and
pull down top of filter.
9
3-5
B
3-6
Removing and replacing
filter
Lift out filter (B) and hand wash it in
cold water with mild detergent.
Let filter air dry and reposition it on
the side of the cleaner.
Reposition bag door.
Should you want to replace this filter,
ask for
HOOVER part No.
38766008.
Do not operate cleaner without
either the secondary or final filter
in place.
Check agitator shield
Because your cleaner picks up so
well, we strongly recommend you
check for debris accumulation
under the agitator shield each time
you clean the filters.
Removing debris under the shield
will help maintain your cleaner’s
excellent pick up and suction.
Remove debris as follows:
1. Disconnect cleaner from electri-
cal outlet.
2. Check for dirt accumulation by
removing bottom plate (Fig. 3-10),
removing agitator (Fig. 3-11), and
lifting agitator shield (Fig. 3-13).
3. Remove any debris and replace
shield, agitator and bottom plate
(Figs. 3-13 to 3-15).
3-7
Removing lens
Disconnect cleaner from electrical
outlet.
Using a screwdriver, remove the two
screws as shown and lift off lens.
Installing bulb
Pull old bulb straight out of socket.
Push new bulb straight into socket
until locked in place.
Excessive force is not required.
Replacing lens
Reposition lens and secure with the
two screws.
3-8
Headlight replacement
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb,
Hoover part No. 27313101
.
3-9
