3-16
3-17
Carpet/Upholstery Detergent according to
instructions for Figs 2-13 to 2-14.
5. Attach tool to end of hose.
13
ed in Figs. 3-10 to 3-12.
2. Place handle in upright position.
Agitator
brushes will not rotate while handle
is in upright position.
3. Fill clean water tank according to instruc-
tions for Figs. 2-9 to 2-12.
4. Fill detergent container with HOOVER
Drain suction hose by turning carpet cleaner
ON and holding nozzle up for several min-
utes.
Do not press trigger.
Unplug carpet cleaner from electrical
outlet.
Disconnect hose and solution tube
from carpet cleaner.
Drain solution tube by placing round end in
sink and raising nozzle above your head.
Press the trigger.
Read “Before you begin cleaning”
instructions on page 9.
some spots may need for removal.
G. Scrub module with detachable
scrub pad
attaches to the base of the
SpinScrub™ hand tool (in place of brush
module). Can be used to scrub stubborn
areas such as scuff marks, dried spills, and
in hard to reach areas on hard surfaces.
How to attach tools
Unplug carpet cleaner from electri-
cal outlet.
1. Place handle in upright position and
remove hose from rack.
All tools attach to the hose in the same man-
ner:
2. Connect tool to hose by sliding it onto con-
nector until the tab (H) locks it securely.
Using your thumb,
push forward and up
on the
latch (I)
to remove tool.
Select tool
Your model includes some combination of
the following tools, but
may not include
them all.
3-14
After using tool
E
F
G
3-15
H
I
1. Attach hose and solution tube as instruct-
The tool caddy can be removed and hung on
a coat hanger for storage.
Continued
➜
D
B
3-13
Attaching scrub module
Available at additional cost if not included
with your cleaner.
1. Open the tool door and remove the
SpinScrub™ hand tool.
2. Grasp the sides of the brush module and
lift it from the base (J).
3. Snap scrub module onto the base.
Note:
It may be necessary to rotate the
scrub module (K) slightly so it will align prop-
erly to the base.
3-18
J
K
To remove hose: Squeeze latches (D) on top
and bottom of hose. Remove hose from port.
Close door.
Remove solution tube (B) from solution con-
nection port.
