Hoover Spritz AL71SZ02, User Manual

Page: 8 / 10

- 7 -
User checklist
If your cleaner is not working properly run through the following checklist.
1 .Is there a working electricity supply to the cleaner? Check with another
electrical product.
2. Is the dust container full or choked with fine dust? To empty the dust container
sec the instructions on page 5/6.
3. Is the hose blocked? To clear a blockage, see the instructions on page 7.
4. Is there a blockage in the cleaner base? To clear a blockage, see the
instructions on page 7.
5. Are the filters blocked? To clear the fitters, see the instructions on page 6.
6. Are the brushes rotating correctly? To check the brushes, see the instructions
on page 7.
7. Has the cleaner overheated? If so, it will take about 45 minutes to reset itself.
If there is any doubt call the Hoover Service Office for advice. They may be able
to assist you over the telephone. A service charge will be made if the cleaner is
examined and found to be in
working order, has not been assembled in accordance with these instructions or
has been used incorrectly.
Filter Maintenance
To maintain optimum performance, please follow these steps:
1. Rinse filter under hand warm water.
2. Do not scrub the filter.
3. Remove the excess water with a dry cloth and leave to air dry for 24 hours.
Remove pre-motor filter.
Remove separator screen.
Wash the pre-motor filter under hand
warm water and leave to air dry for 24
hours or until completely dry.
Do not scrub or brush the filter as
permanent damage will occur.
Warning!
A thermal cut out switches off the cleaner to prevent overheating if it is used when
full or there is a blockage or dirty filters. If this should happen switch off, unplug and
correct the fault.
It will take about 45 minutes for the cut out to automatically reset.
iMPOrTanT: Do not run cleaner over the supply cord as this could damage the
supply cord insulation.