9
Actual model may vary from images shown.
CyClone separator
how to Clean
Remove dirt cup as described in Fig. 3.1.
3.3 Twist filter assembly counterclockwise. Remove
assembly from dirt cup.
3.4 Dirt and debris can be cleaned from the filter
assembly with a towel or rag.
Replace the filter assembly on the dirt cup,
and twist it clockwise to secure into position.
3.5 Replace dirt cup.
CAUTION
!
!
To reduce the risk of personal injury, unplug
vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place.
3.3
3.4
3.5
filters
CAUTION
!
!
To reduce the risk of personal injury, unplug
vacuum before servicing.
Do not use vacuum without dirt cup or filters
in place.
IMPORTANT
Both Pre- and Post-Motor Filters can be rinsed
in warm water (max 40°C). Allow to air dry for
24 hours before replacing. Do NOT use any
detergents or boiling water to wash filter.
If desired, additional filter is available. Ask for
Hoover
®
Part No. 304285001.
what to buy: pre-Motor filter
when to Clean
It is recommended that the Pre- and Post-Motor
filter should be checked and cleaned periodically
depending on the frequency of use and the volume
of dirt being picked up on each occasion.
how to Clean
Remove dirt cup as described in Fig. 3.1.
3.6 Pull up on dirt cup latch to open.
3.7 Remove Pre-Motor filter.
3.8 Gently tap the filter on the inside of a trash
receptacle to remove dust and dirt.
3.9 Hold filter under running water to clean.
Replace filter in dirt cup and close lid securely until
it clicks.
Replace dirt cup as described in Fig 3.5.
pre-Motor filter
3.6
3.7
3.8
3.9
IMPORTANT
The cyclone separator should not be submerged
in water.
