- 4 -
1
PREPARING TO USE YOUR CLEANER
POWER SWITCH SETTING
CARPET CARE CONTROL
SELECTOR
CLEANER LOCK RELEASE
Insert handle into body of cleaner. Slide into position.
Ensure handle is flush with body of cleaner.
Tighten large screw (pre-fitted to handle upper hole).
Insert small screw into handle lower hole and tighten.
Check that the dust container is fitted.
Switching on and off
Push bottom of the On/Off switch to switch on.
Push top of the On/Off switch to switch off.
The carpet care control selector raises or lowers the
height of the nozzle. The nozzle height will not change
until the handle is released. Try various settings until you
get the best results for each of your carpets.
Ensure that the cleaner
is in an upright (parked)
position.
Slide selector to the
position best suited to
depth of carpet pile.
Using this cleaner for carpets with pile greater than 30mm
is not recommended.
Unlock the cleaner by pressing
down on pedal with foot. For
floor cleaning under low
furniture and some
maintenance tasks
simply press the
pedal again and
lower handle
to the floor.
IMPORTANT: When cleaning hard
floors such as vinyl or linoleum, move
the “Carpet Care Control Selector” to
the Hard floor position. Failure to do so
may cause damage to the floor surface.
!
- 4 -
0565-5296.indd 4
29/11/2007 16:23:37
