GB
USER CHECKLIST
should you have a problem with the product, complete this simple user checklist before
calling your local Hoover service.
•
Is there a working electricity supply to the cleaner? Please check with another
electrical appliance.
•
Is the dust bag over-filled? Please refer to ‘Cleaner Maintenance’.
•
Is the Filter blocked? Please refer to ‘Cleaner Maintenance’.
•
Is the hose or nozzle blocked? Please refer to ‘Removing a blockage from the
system’.
•
Has the cleaner overheated? If so, it will take approximately 30 minutes to
automatically reset.
IMPORTANT INFORMATION
HOOVER spares and Consumables
Always replace parts with genuine HOOVER spares. These are available from your local
HOOVER dealer or direct from Hoover. When ordering parts always quote your model number.
Quality
HOOVER’
s factories have been independently assessed for quality. Our products are
made using a quality system which meets the requirements of ISO 9001.
Your Guarantee
The guarantee conditions for this appliance are as defined by our representative in the
country in which it is sold. Details regarding these conditions can be obtained from the
dealer from whom the appliance was purchased. The bill of sale or receipt must be
produced when making any claim under the terms of this guarantee.
subject to change without notice.
*Certain Models Only ** Certain models only, nozzles may vary according to model
3
Cleaning the permanent cloth dust bag* (certain models only)
To maintain optimum performance we recommend that you wash the permanent cloth
dust bag under hand warm water after every 5 full bags. Remove excess water and leave
to dry fully before replacing.
Removing a blockage from the system
If the bag check indicator is red:
1.
Check if the bag is full. If so refer to ‘Replacing The Dust Bag’.
2.
If it is not full, then;
A.
Do the filters need cleaning?
If so refer to ‘Cleaning the Filter’.
B. Check if there is any other blockage in the system - Use a rod or a pole to
remove any blockage from
telescopic tube* or flexible hose.
WARNING*:
-The bag check indicator will remain red if the cleaner is used when the bag is
full, if there is a blockage or if the filters are dirty. If used for a period over ten 10 minutes with
the bag check indicator red, an electronic cut out will switch the cleaner off to prevent any risk
of overheating. If this should happen, switch the cleaner off, unplug and correct the fault (see
‘Removing a blockage’). The cut out will automatically reset upon switching the cleaner back on.
ACCESSORIES AND NOZZLES
To obtain the best performance and efficiency it is recommended that the correct nozzles
are used for the main cleaning operations. These nozzles are indicated in the diagrams
by the letters
GP
,
HF
or
CA
.
A nozzle type
GP
can be used to clean both carpet and hard floor.
A nozzle type
HF
is suitable for use only on hard floor.
A nozzle of type
CA
is suitable for use only on carpet.
The other nozzles are accessories for specialist cleaning tasks and are recommended
for occasional use only.
All accessories can be fitted to the end of the hose handle
[2]
or to the end of the tube.
2 in 1 Tool
combines several functions into one tool
[U]
:
Crevice Tool –
For corners and hard to reach areas.
Dusting Brush –
For bookshelves, frames, keyboards and other delicate areas.
Pet Hair Remover Mini Turbo Nozzle*
– Use the mini turbo nozzle on stairs or for deep
cleaning on textile surfaces and other hard to clean areas. Particularly suitable for pet
hair removal.
Allergen Remover Mini Turbo Nozzle*
– Use the mini turbo nozzle on stairs or for
deep cleaning on textile surfaces and other hard to clean areas. Particularly suitable for
allergen removal.
Parquet Nozzle*
– For parquet floors and other delicate floors.
IMPORTANT:
Do not use mini turbo nozzles on rugs with long fringes, animal hides and
carpet pile deeper than 15mm. Do not keep the nozzle stationary while the brush is rotating.
