Hoover HLXV9TG, Booklet

Page: 17 / 28

EN
17
l
This button allows to delay the start of the
programme from
30 minutes ( 1 hour on
some models) to 24 hours in 30 minutes
intervals ( 1 hour on some models).The
delay selected is shown on the display.
l
After pressing the START/PAUSE button
the time showed decrease minute after
minute.
l
It's possible transform a cycle from
automatic to programmed, up to
3
minutes after the start of the cycle.
l
The progressive pressure increases the
time in
10 minute intervals. After this
selection to reset the automatic drying
functioning is necessary to switch off the
dryer.
l
In case of incompatibility, all indicator
lights flash quickly for 3 times.
l
If the programme selector is positioned on
the rapid programmes, the progressive
pressure of the key allows you to choose
the cycle time between:
30-45-59 minutes .
This button allows you to store the options
set on a cycle.
MEMORY:
when the cycle is running push the button
MEMO for 3 seconds. The writing MEMO
(all the digit on some models) will blink for 2
seconds and the options connected to the
cycle selected will be set.
RECALL:
after the selection of the cycle push the
button
MEMO for recall the stored options
(not the cycle).
l
This button allows to set the desired
dryness level editable option up to
5
minutes after the starting of the cycle:
Ready to Iron : it leaves the garments
slightly wet to facilitate ironing.
Dry Hanger : to get garment ready to
be hang.
Dry wardrobe : for laundry that can be
directly stored.
Extra-dry : to get completely dry
garments, ideal for full load.
l
This appliances is equipped with Drying
Manager function. On automatic cycles,
each level of intermediate drying, prior to
the reaching the selected one, is
indicated by flashing the light indicator
corresponding to the degree of drying
reached.
In case of incompatibility, all indicator
lights flash quickly for 3 times.
l
During the cycle the option sets alternate
movements of the drum to reduce the
folds and automatically sets the drying
level to
"Ready to Iron" (the drying level
can be changed after selecting the
options). Moreover this option activate an
anti-creases movement of the drum pre
cycle in case of activation of the delay
and at the end of drying cycle. It is
activated every 10 minutes, up to 6 hours
after the end of the drying cycle.
DELAY START button
Opening of the porthole with delayed
start set, after re-closing the porthole,
press start again to resume the counting.
TIME CYCLE SELECTION/RAPIDS
button
MEMO button
The delay start function can't be
memorized.
DRYING SELECTION button
ANTI CREASE button