5
INSTALLATION: "ELECTRICAL CONNECTION"
The mains electricity supply connected to the appliance should comply with the norms
in force in the country of installation.
HOOVER declines all responsibility for any damage that may be caused by unsuitable
or unreasonable use.
• Any queries regarding the power supply cord should be referred to After Sales
Service or a qualified technician.
Warning :
• Always check before any electrical operation, the supply tension shown on the
electricity meter, the adjustment of the circuit-breaker, the continuity of the
connection to earth to the installation and that the fuse is suitable.
• HOOVER cannot be held responsible for any accidents resulting from the use of an
appliance which is not connected to earth, or with a faulty earth connection continuity.
The hob is equipped with a supply cord type H05RR-F - aera 3G2,5 mm². This power
cord enables you the connection exclusively to single phase 220-240 V~ or two phases
220-240 V2~.
To proceed to the new connection, you mus adhere the following instructions
• Before making the connection, make sure that the installation is protected by a suitable
fuse, see table on next page, and that it is fitted with wires of a large enough section to
supply the appliance normally.
1 - Operations to be carried out on the existing connection (if necessary) :
. Turn the hob against the worktop.
Terminal
block
Cable
Shunts
clamp
bars
Earth
green/
yellow wire
1 . Unscrew the cover
2 . The hob is supplied for a single phase
connection : 220-240 V~ or
two phase : 220-240 V2~.
. Remove the screws retaining the terminal block which contains the shunt bars and the
conductors of the supply cord.
. Unscrew the cable clamp to release the power supplying cord.
. Pull out the supply cord.