DRAIN HOSE : FITTING INSTRUCTIONS
WARNING!
Switch off and remove the
tumble dryer plug from the
electricity supply
before carrying out any work.
Fit
t
he
Hose
a
s Follows:
1.
Tilt the machine
backwards.
2.
Remove the
bottom
protector panel, by
pulling carefully to the
left side
.
3.
The waste water
pipe
is situated at the
right-hand side of the
m a c h i n e (
s e e t h e
picture
). A grey hose
connects to the
bridge
at the left hand side of
the machine.
Using
pliers, remove the pipe
retaining clip from
the
bridge.
4.
Pull the hose off the
bridge connection.
5.
Attach the
black
hose from the kit,
(
using the
connector
a n d p i p e c l i p s
supplied
)
, to the
hose
removed from the
bridge connection.
6 .
P l a c e t h e t a p
supplied by the kit to
close the remaing
hose.
7.
Feed the drain hose
through the hole in the
b o t t o m p r o t e c t o r
panel
.
8.
Carefully slide the
bottom protector panel
back into
position
ensuring that the hose
is not
trapped
.
9.
Once the machine is
in place the feet should
be adjusted to ensure
that the new hose
does
not kink when pushing
the tumble
dryer into
position.
10.
Connect the new
drain hose to the waste
Water pipe.
11.
Connect to the
m a i n s e l e c t r i c i t y
supply.
To avoid emptying the water container after
each drying cycle, the water can be
discharged directly to a waste water drain pipe
(the same drainage system as household
sinks). Water Bye-Laws prohibit connection to
a surface water drain. The waste water drain
pipe should be located adjacent to the tumble
dryer.
The kit consists of:1 hose and 1 tap.
EN
6
