EN
13
l
By pressing this button, it is possible to
reduce the maximum speed, and if you
wish, the spin cycle can be cancelled.
spin speed cancelled.
l
To reactivate the spin cycle press the button
until you reach the spin speed you would
like to set.
l
It is possible to modify the spin speed
without pausing the machine.
l
This button allows you to change the
temperature of the wash cycles.
cold wash.
l
It is not possible to raise the temperature
over the maximum allowed for every
programme, in order to save the fabrics.
l
This button allows you to pre-programme
the wash cycle to delay the start of the
cycle for up to
24 hours
.
l
To delay the start use the following
procedure:
- Set the required programme.
- Press the button once to activate it (
h00
appears on the display) and then press
it again to set a
1 hour
delay (
h01
appears on the display). The pre-set
delay increases by
1 hour
each time the
button is pressed, until
h24
appears on
the display, at which point pressing the
button again will reset the delay start to
zero.
- Confirm by pressing the
START/PAUSE
button (the light on the display starts to
flash). The countdown will begin and
when it has finished the programme will
start automatically.
l
It is possible to cancel the delay start by
turning the programme selector to
OFF.
If there is any break in the power supply
while the machine is operating, a special
memory stores the selected programme
and, when the power is restored, it
continues where it left OFF
l
By selecting this button there is a choice
of 3 levels of wash intensity, depending
on how much the fabrics are soiled (can
be used only on some programmes as
shown in the table of programmes).
l
Once the programme has been selected
the indicator light will automatically show
the wash time set for that programme.
l
Selecting a different wash time the
relevant indicator will light up.
SPIN SPEED button
To prevent damage to the fabrics, it is
not possible to increase the speed
over that which is automatically
suitable during the selection of the
program.
The machine is fitted with a special
electronic device, which prevents the
spin cycle should the load be
unbalanced.
This reduces the noise and vibration in
the machine and so prolongs the life of
your machine.
TEMPERATURE SELECTION button
DELAY START button
WASH TIME button
