Hoops PD-P-G, Owner'S Manual

Page: 6 / 12

PRO DUNK® ASSEMBLY INSTRUCTIONS
(~Day 5)
7. Loosen the top four 16mm J-Bolt Hex Nuts (L) from the 16mm Anchor J-
Bolts (K). Leave Anchor Footing Template (N) in place.
8. Put the 16mm Anchor J-bolt Washers (Z) on each Anchor J-Bolt (K).
9. Place the Vertical Post (A) down over the footing making sure not to
damage the 16mm Anchor J-Bolts (K) threads. Using the 16mm J-Bolt
Gusseted Hex Nuts With Built-In Washer (BB), bolt down Vertical Post (A)
finger tight with two metal ears on the Vertical Post (A) to the rear.
10. Level the Vertical Post (A) by adjusting the 16mm J-Bolt Hex Nuts (L)
located underneath the flanged base plate of the Vertical Post (A). Then
tighten top 16mm J-Bolt Gusseted Hex Nuts With Built-In Washer (BB)
against the top side of the flanged base plate of the Vertical Post (A).
11. Slide the Main Extension Arm (B) over the top of the Vertical Post (A) and
attach to the lower pivot tube with a 18mm X 33cm Hex Bolt (P) and a
18mm Lock Nut (Q).
12. Next attach the Crank Adjustment Cylinder (F) using an 18mm X 33cm
Hex Bolt (P) at the top and 16mm X 15cm Hex Bolt (H) at the bottom.
Tighten each with a 18mm Lock Nut (Q) and 16mm Lock Nut (J).
13. Line up the hole located in the Rim Height Indicator (G) which is plastic
with a hole in one end over the hole in one of the second set of welded
tubes in the Main Extension Arm (B). Attach both Spring-Assist Cartridges
(E) to the Main Extension Arm (B) using an 20mm X 33cm Hex Bolt (X)
and 20mm Lock Nut (Y). In order to attach both Spring-Assist Cartridges
(E) at the bottom, lower the open end of each Spring-Assist Cartridge (E)
down over the top of each welded tab as shown in
Figure A . Use the
16mm X 19cm Hex Bolt (I) and 16mm Lock Nut (J) to attach them to the
welded tabs. You may need to turn or rotate the Spring-Assist Cartridges
(E) to line up holes. The Rim Height Indicator (G) should hang freely along
the outside of one of the Spring-Assist Cartridges (E). Next, remove and
discard the blue plastic spreader tube from Spring-Assist Cartridge (E).
14. Attach Parallel Linkages (C) to Vertical Post (A) with a 18mm X 30cm Hex
Bolt (O) and a 18mm Lock Nut (Q).
NOTE: It does not matter which end of the
parallel link you attach to the vertical post.
CAUTION: Injury may occur if linkages are
allowed to fall off main arm during assembly.
15. [THIS STEP HAS ALREADY BEEN DONE DURING PREASSEMBLY]
Next, lay the H-Frame Backboard Mount (D) down into backboard aligning
the four top and bottom holes in the H-Frame Backboard Mount (D) with
the four holes in the top and bottom of the backboard. Check to make sure
6