2/5
Diagram 2
3 Attach slats (D) to side rails (C), align pre-drilled holes on the slat to holes on the cleat of side rail
(C), using screws (J) to tighten both. (See diagram 3)
Diagram 3
Note: You can change the height of slat by adjusting the height of cleat on side rail as shown in
diagram 4. Remove bolt (T1), lock washer (R1) and flat washer (S1) from the cleat by turning
the bolt (T1) with allen wrench (P) in anti-clockwise direction. Adjust the cleat to a desired
position, and then secure lock washer, flat washer, bolt in a clockwise direction by turning with
allen wrench.
Diagram 4
You can adjust the height of center supports (E) as shown in Diagram 5 to meet your need by the
following steps.
1. Unscrew bolts on center supports (E) with allen wrench (L).
