To connect system cables
1. Connect the USB mouse and USB keyboard extension cables to the USB connectors.
2. Connect the audio cable from the amplifier to the audio (green) port
3. If you are not using Fault Tolerant Ethernet (FTE), connect the Ethernet cable to the RJ-45
connector on the onboard Network Interface port. This port can be located near the USB ports at
the back of the workstation.
If you are using FTE, you need to connect the FTE cables according to the instructions in the Fault
Tolerant Ethernet Installation and Service Guide.
4. If your console has an OEP, connect the serial cable from the OEP adapter to the COM1 port of the
workstation.
5. If LCN MAU is present, and is pre-installed in the treadle area. Connect the LCN MAU cable to the
MAU connector on the LCNP4e2 card. If other networks are being used, configure their MAU and
cables appropriately.
6. Connect the one or two USB Hub cables to the workstation USB port(s).
7. Connect the workstation power cable to the workstation.
8. Arrange all cables so that the enclosure can be raised and lowered without pinching, jamming, or
straining any cable.
9. The lower valance of the back panel has ten 2 inch holes. These are for both cable passage and
air flow. Four holed plugs are present. Install or move the holed plugs to the left side of the lower
valance, into the left side holes. The left side holes are not filled with cables.
10. Close the enclosure, securing it with the lock and, if necessary, shipping screws, as shown in the
sample image below.
- 30 -
Chapter 3 - Installing
