Version 1
XYR400E Ethernet Modem
72
5/1/08
Command used for above screen shot is Arp –a. It shows the PC’s direct IP address of
192.168.0.17 as also shown before with IPCONFIG command. The other IP address shown with its
associated MAC address is another device with a connection to the PC. In this example it is the IP
address of a PLC connected to the PC also.
Arp –n lists all the commands available for this function.
4.4.4
ROUTE
Route is used for the Router function. This is where you are joining 2 different networks together
via the XYR 400E
refer to Section 1.1
The XYR 400E can only accept 1 Routing table. That is it can only accept one router per network
of radios. On the Router radio network PC a routing rule needs to entered to allow access between
Network A and Network B. This is entered in the command prompt as per all other instruction
above.
Route PRINT will show all active routes on PC,
Network A
Access
Point
Router
Client
Bridge
Network B
Route ADD will add a routing table to network,
route DELETE <
destination netmask gateway interface>
will delete the unwanted routing table
route CHANGE modifies an existing route.
An example of a routing table is shown for the configuration below,
Network A Settings
Client Bridge Settings
IP Address 192.168.0.17
Gateway IP 192.168.2.51
Subnet Mask 255.255.255.0
Ethernet IP 192.168.2.50
Gateway IP 192.168.0.1
Subnet Mask 255.255.255.0
Wireless IP 192.168.2.50
Subnet Mask 255.255.255.0
Access Point Router Settings
Network B Settings
Gateway IP 192.168.0.1
IP Address 192.168.2.201
Ethernet IP 192.168.0.191
Subnet Mask 255.255.255.0
Subnet Mask 255.255.255.0
Gateway IP 192.168.2.51
Wireless IP 192.168.2.051
Subnet Mask 255.255.255.0
