4
SETTING UP YOUR HUMIDIFIER
Unpack the Humidifier
Keep this Owner’s Manual for reference
• Remove packaging materials. Remove twist tie from power cord and extend
power cord to full length.
• Place on a firm, level, water resistant surface a minimum of 12” (30cm) from
any walls. Mist should be directed away from any walls, bedding and furniture.
Hard Water and White Dust
• High mineral content in your water, also known as hard water, may cause a white mineral residue to
accumulate on surfaces in the room near the humidifier. This mineral residue is commonly referred to as white
dust. The higher the mineral content (hardness) of your water, the greater the potential that an ultrasonic
humidifier may produce white dust.
• White dust is not a result of a defect or flaw in the humidifier. It is a result of the amount of minerals suspended
in the water you are using.
• To reduce white dust, use distilled water or a Protec PDC51V2 (PDC51CV2 in Canada) Demineralization
Cartridge available through Consumer Relations; see back of this manual.
FILLING/REFILLING
NOTE:
Tank should be carried using two hands; one hand on the Tank Handle and the other supporting the
bottom of the Tank.
Kaz USA, Inc. will not accept responsibility for property damage caused by water spillage.
This Humidifier holds 1/2 gallon (1.9L) of water (tank and reservoir combined).
Filling:
ALWAYS
turn the the humidifier off before removing the Water Tank.
1. Remove Water Tank and turn upside down. Remove Tank Cap by turning counterclockwise (left). Fill Tank with
cool water.
DO NOT
fill with warm or hot water.
2. Replace Tank Cap by turning clockwise (right), aligning arrow to lock symbol. Be sure Gasket is in place.
3. Place Tank on Base. Water will drain from the Tank into the Reservoir when the Plunger is engaged.
1
2
3
