Mounting the Unit on the Wall
Page 13
Combined Assembly - Single and Triple Modules
Combined Assembly - Single and Triple Modules
Combined Assembly - Single and Triple Modules
Combined Assembly - Single and Triple Modules
A combined wall assembly of single and triple modules allows you to
create units consisting of 2, 4 and 5 units. This procedure consists
of the following steps:
1.
Drill the necessary holes in the wall (2 plastic dowels for each
module), so that the lower plate will cover the hole through which
the cables pass.
2.
Insert the cables in the cable clamp without pulling out the screws.
3.
Link the frames together by inserting the two enclosed attachment
clips at the rear of the frames (see Figure 6 and Figure 7).
4.
Use the dowels to fasten the frame to the wall. Make sure that
the lamellar connector is in the
UP
position.
5.
Adjust the length of the cables so that they protrude by ~10cm
from the wall, and fasten them to the cable crimp.
6.
Intertwine the terminators of the cables from the wall and the
extension cable terminators, and fasten them to the cable crimps.
7.
Fasten the cable crimp to the contacts in the direction shown in
Figure 6 and Figure 7.
8.
Place the remainder of the cable inside the frame and lock the cable
clamp.
NET1
NET2
GND
+12V
NET1
NET2
GND
+12V
Attachment
clip
Attachment
clip
Figure 6: Combined assembly of two single module wall units
