Mounting the Unit on the Wall
Page 11
Mounting the Unit on the Wall
Mounting the Unit on the Wall
Mounting the Unit on the Wall
Mounting the Unit on the Wall
Horizontal Assembly – Single Module
Horizontal Assembly – Single Module
Horizontal Assembly – Single Module
Horizontal Assembly – Single Module
To assemble the unit in a horizontal position, follow these steps:
1.
Drill two holes in the wall (to accommodate the 2 plastic dowels),
so that the frame will cover the hole through which the cables
pass.
2.
Insert the cables in the cable clamp without pulling out the screws.
3.
Use the dowels to fasten the frame to the wall. Make sure that
the lamellar connector is in the
UP
position.
4.
Adjust the length of the cables so that they protrude by ~10cm
from the wall, and fasten them to the cable crimp.
5.
Fasten the cable crimp to the contacts in the direction shown in
Figure 4.
6.
Place the remainder of the cable inside the frame and lock the cable
clamp.
Figure 4: Wall position — horizontal position (single module)
